|
|
|
|||||||
| Mini Buggy General Discussion General Discussion forum for Mini Buggies. (American Sportworks, HammerHead, Carter, etc) |
|
|
Thread Tools |
|
#1
09-09-2015, 09:35 PM
|
|||
|
|||
Carbide 150 Seat Covers
Hey everyone.
I wanted to get some advice about putting a Carbide 150 back together. A co-worker of my wife gave us this cart because it didn't run. It had been sitting outside for a while, so a lot of the fasteners are rusty, and the starter motor had failed. So, after a new starter, new carburetor, and some new gas, its running but it needs some TLC in the "looks" department. I tried contacting American Sportworks about new seat covers but they don't have any available. Is there any place to get new seat covers for these? I also need to replace most of the rubber parts (bushings, uv boots, etc.), and the headlight switch is bad. Are there any other suppliers than American Sportworks? Appreciate the help, guys!!! 
|
|
#2
09-10-2015, 10:09 PM
|
||||
|
||||
|
Quote:
__________________
Hammer head Single seater know as herbie under construction Aluminum fuel tank, aluminum wheels, custom fuel/cargo rack, entire rewire, trail tech vapor, ported big valve head, a12camshaft, 12 gram sliders, straight intake, kirkey wide seat, front end extension. 4 point harness, welded cage. Hammerhead exhaust. Blade Single Seater Restore welded cage, engine build, new wiring harness/electric box, spun aluminum fuel tank. |
|
|
