|
|
|
|||||||
| 150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
|
Thread Tools |
|
#1
06-22-2016, 12:53 PM
|
||||
|
||||
Which performance exhaust for hammerhead GT 150
Hey guys, I'm looking to get a good aftermarket exhaust system for my 2008 hammerhead GT 150 with the GY6 motor...I been looking and all I can really find is the MRP exhaust and they want a little more than I wanted to pay for...but, if it will make that much of a difference I might could reconsider it...but, just need a good exhaust system...any suggestions????
|
|
#2
06-22-2016, 01:03 PM
|
||||
|
||||
I've used hammerhead exhaust and love the sound, and performance, it's a little pricey at $250. I believe JD still makes a custom exhaust for the buggies but never used his before.
__________________
Hammer head Single seater know as herbie under construction Aluminum fuel tank, aluminum wheels, custom fuel/cargo rack, entire rewire, trail tech vapor, ported big valve head, a12camshaft, 12 gram sliders, straight intake, kirkey wide seat, front end extension. 4 point harness, welded cage. Hammerhead exhaust. Blade Single Seater Restore welded cage, engine build, new wiring harness/electric box, spun aluminum fuel tank. |
|
#4
06-22-2016, 10:20 PM
|
||||
|
||||
|
I like my TK exhaust (Turbo Kit)
Seen in post #102 http://buggymasters.com/forum/showth...?t=2601&page=2 And if you want to be on the cheap side: A stock header pipe with a used FMF slip on silencer worked pretty good for me too. As seen in post #7 http://buggymasters.com/forum/showthread.php?t=2601
__________________
My Yerban assault vehicle: 2.2mm stroker crank, 62mm Nikasil cyl, Taida large vavle head, American made valve springs, ported intake manifold, TM 28mm carb, stock CDI, Bando coil, TK exhaust, stock CVT except for the 14g sliders, 13/40 internal gears, 16T drive, 31T axle sprocket, 22" rear tires, and ONE BIG POTATO CANNON mounted on top.......... |
|
|
