|
|
|
|||||||
| 150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
|
Thread Tools |
|
#1
06-08-2017, 12:09 PM
|
|||
|
|||
rebuilt Twister with 68mm piston
I have a hammerhead twister 150cc with a 58mm piston and a 15mm pin. The wrist pin is worn .01" where the rod engages it. The rod measures the same as the piston holes, so I'm thinking the pin just had a bad heat treat on it. I'm trying to find a new piston, cylinder and pin for this thing. Anyone know where to find this? The place I bought the last one has gone out of business.
Thanks ir Last edited by irmachinist; 06-08-2017 at 12:16 PM. |
|
|
