|
150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
Thread Tools |
#1
|
||||
|
||||
150cc Dazon - replacing seals for transmission shaft
Hello everyone. So I noticed a seal is very worn on my transmission shaft. I already have the cover off, and don’t want to go through the hassle to take it off again due to another oil leak. I want to replace the seal, which one am I buying? The bottom three? How do I replace it (how does this shaft come off)?
|
#2
|
||||
|
||||
There is a number on the seal, actually it will be the seal dimension. If you can't find the #'s than using a caliper measure the outside and inside dimension of the seal along with the width. Make sure your measurements are in millimeters. I would check all the bearings as well. Usually when a seal goes it is due to a bad bearing.
|
#3
|
||||
|
||||
So I got it apart.. seal looks good, and bearing is destroyed. I cannot find the part online.. all I found on part of the busted bearing is spgbc 6005.
Last edited by Sk8almost44; 02-15-2019 at 02:34 PM. |
#4
|
||||
|
||||
Would this kit help you?
http://www.buggydepot.com/product/55...build-kit.html Or try here, https://www.dazonparts.com/go-kart-parts/go-kart-parts-dazon/dazon-raider-150-2006-and-earlier/dazon-raider-150-2006-and-earlier-transmission?page={page}
__________________
Tom SunL 250cc Carter 150cc Yerf Dog 150cc Last edited by TBS99; 02-15-2019 at 04:02 PM. Reason: added |
|
|