|
150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
Thread Tools |
#1
|
|||
|
|||
wont turn over
got new battery charged it wont turn over replaced clutch could that be the problem sound like everything is grinding in the gear box sounds like i have troubles
|
#2
|
||||
|
||||
is the grinding you hear from trying to start it or coming from the gear box? test the battery to make sure you have a full charge. if so, then it could be the starter solenoid or even the starter. if it's grinding, i would lean more towards the starter. the solenoid would make more of a clicking sound when it tries to engage the starter. make sure all your wires are connected good. a bad ground could cause the starter not to engage too. try these things and follow up and let us know what happens.
__________________
07 HH250SS UNI HIT CLUTCH DR. PULLEY VARIATOR RED MAIN 17g ROLLERS 12T/45T SPROCKETS IRIDIUM PLUG HP CDI & COIL LED LIGHTS ASW CARBIDE UNI 12g SLIDERS RED MAIN 39T SPROCKET (coming soon) |
#3
|
|||
|
|||
will do thought maybe i should take clutch off to see if its too tight its like it wont turn and battery leads get hot
|
#4
|
||||
|
||||
what kind of buggy/engine do you have? unless the belt and clutch are frozen it shouldn't keep the engine from turning over. you could disconnect the belt just to be sure and then try it.
__________________
07 HH250SS UNI HIT CLUTCH DR. PULLEY VARIATOR RED MAIN 17g ROLLERS 12T/45T SPROCKETS IRIDIUM PLUG HP CDI & COIL LED LIGHTS ASW CARBIDE UNI 12g SLIDERS RED MAIN 39T SPROCKET (coming soon) |
#5
|
|||
|
|||
the gy6 150cc yes the grind is like the gears it turns for a little but then just like not enough power to turn it and i got a new battery and its charged 100 % its a loud grind not normal i could move clutch by hand
|
#6
|
|||
|
|||
im not a mechnic but can follow directions i got the clutch on by watching buggy masters vid thats why i love this site
Last edited by charles; 03-28-2010 at 06:22 PM. |
#7
|
|||
|
|||
i have grounds hooked to clutch box clean ground no paint on ground part
Last edited by charles; 03-28-2010 at 06:21 PM. |
#8
|
|||
|
|||
so u think starter is best next step?
|
#9
|
||||
|
||||
charles
take the sparkplug out then try cranking if still weak pull starter next and test it olderthan
__________________
olderthan 2008 tomberline punisher 1500 spring 12g sliders 30mm cv pumper carb uni filter no rev cdi polaris xlt snowmobile shocks for front w/550 magnum springs & blaster fronts on rear and another buggy built working on mods gk-13 white spring 17 gram sliders so far |
#10
|
|||
|
|||
ty well i took off clutch plate and my front clutch wheel was grinding on cover is that one shot now or can it still work with that front outside wheel ground down a little?
|
|
|