|
|
|
|||||||
| Other tech issues For all other technical issues. Think frame, suspension, steering, brakes, etc |
|
|
Thread Tools |
|
#1
05-10-2010, 03:55 PM
|
|||
|
|||
Rear axle bearing seals
I took the rear axle off my ASW Carbide 150 to change the sprocket size. I noticed that with only 450 km on this Kart that the outer axle seals were chewed up. I took the outer seals off to change the seals and discovered that there was no grease in the housing so the seals had been running dry. The housing was full of grit from the seal failure. I mentioned this to my dealer's service man and he said this is common, the Chinese put in a water based grease which dries up and disappears. Sounds a little far fetched to me, since when I brushed out the dust the seal housings were sparkling clean. My guess is that since this failure happened in less than 450 km that there never was any grease in the rear shaft housings.
|
|
#2
05-10-2010, 07:16 PM
|
||||
|
||||
|
i would say the bearings were never greased
get a manual greaser that attaches to a grease gun or put grease in your hand and grease the bearing that way by rolling the bearing thru the grease i do it both ways
__________________
olderthan 2008 tomberline punisher 1500 spring 12g sliders 30mm cv pumper carb uni filter no rev cdi polaris xlt snowmobile shocks for front w/550 magnum springs & blaster fronts on rear and another buggy built working on mods gk-13 white spring 17 gram sliders so far |
|
#3
05-11-2010, 01:21 AM
|
||||
|
||||
|
The rear axle bearings should be sealed bearings needing no grease. The seals are just dust seals. Grease is a petrolium product and does not mix with water so water based grease!!!! Well what can I say. Be careful cause this guy might try to sell you ocean front property in Montana. TOM
|
|
|
