|
|
|
|||||||
| 150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
|
Thread Tools |
|
#1
05-23-2010, 09:33 AM
|
|||
|
|||
Installing 30mm carb question..
I got the 30mm pumper carb yesterday for my 150 carter buggy. I also installed the new intake with it. My problem is the pumper part of the carb hits the motor or the motor mount. I can't get it to line up completely vertical , i did put it on and it runs i just don't think it looks correct with a little tilt sideways.Will this effect function of my floats and how can i fix this ?Should i order the high rise intake to clear the crossbar it would have to come up alot so i can install the filter. Over all so far i'm not overly impressed about the upgrade maybe i don't have it dailed in right but i thought it would have better proformance..maybe i just expected to much? NOTHING is easy anymore!
|
|
#2
05-23-2010, 10:11 AM
|
||||
|
||||
|
i run the highrise intake on mine and go over the upper bar
you can take out the front long motor mount bolt and replace with two shorter bolts and gain clearance that way
__________________
olderthan 2008 tomberline punisher 1500 spring 12g sliders 30mm cv pumper carb uni filter no rev cdi polaris xlt snowmobile shocks for front w/550 magnum springs & blaster fronts on rear and another buggy built working on mods gk-13 white spring 17 gram sliders so far |
|
#4
05-23-2010, 10:54 AM
|
||||
|
||||
|
yes comes with all bolts and parts
you need a 5mm or 6mm allen to tighten up that is the one i use
__________________
olderthan 2008 tomberline punisher 1500 spring 12g sliders 30mm cv pumper carb uni filter no rev cdi polaris xlt snowmobile shocks for front w/550 magnum springs & blaster fronts on rear and another buggy built working on mods gk-13 white spring 17 gram sliders so far |
|
#6
05-23-2010, 07:20 PM
|
|||
|
|||
|
I use the same thing with my 30mm slide carb. I use that and the metal intake
|
|
|
