|
|
|
|||||||
| Go Kart Engine and Torque Converter Tech Forum for discussing go kart engines and torque converters (Briggs, Tecumseh, Suburu, Comet etc) |
|
|
Thread Tools |
|
#1
07-31-2010, 10:24 AM
|
|||
|
|||
Can anyone post pics of a comet 40 series jack shaft setup?
I have a 11hp briggs and a comet 40 series torque converter going on one of my karts but I don't know anything about jack shaft setups. Any suggestions? I was told bmi made engine mounted jack shaft plates but then I've seen others using a longer shaft mounted to the frame. Pics of your set up would be very helpfull. Thanks Dennis
|
|
|
