|
|
|
|||||||
| 150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
|
Thread Tools |
|
#1
07-15-2010, 10:02 PM
|
|||
|
|||
150cc carbide reverse
I bought this dune buggy/go kart used and it worked great for a couple of weeks. Now it will not start. Un fortunately I am pretty dumb when it comes to this stuff. At the suggestion of my father in law I first cleaned out the carborator and nothing the engine sounds like it wants to turn over but no spark. When he was in town we did check that. Next we replaced the spark plug and still nothing. I just replaced the ignition coil and still the same the engine sounds like it wants to turn over but no spark (I am assuming). Does anyone know what else could be wrong. My step kids are coming home fromtheir dads soon and would like it running for them. Please remember that I an really dumb with engine stuff. Any help is greatly appreciated
JASD 
|
|
#2
07-15-2010, 10:35 PM
|
||||
|
||||
|
Are you getting a spark?
__________________
-JoshMy Ride: ASW Carbide Mods: Dr. Pulley Hit Clutch FMF Slip-On Exhaust No Rev. CDI Uni Air Filter 130 Main jet 1500 RPM main clutch spring 11g sliders 75w Halogen Headlights CARBIDE! |
|
#3
07-15-2010, 10:55 PM
|
||||
|
||||
|
set your valves
__________________
olderthan 2008 tomberline punisher 1500 spring 12g sliders 30mm cv pumper carb uni filter no rev cdi polaris xlt snowmobile shocks for front w/550 magnum springs & blaster fronts on rear and another buggy built working on mods gk-13 white spring 17 gram sliders so far |
|
#4
07-15-2010, 11:23 PM
|
||||
|
||||
|
Your STATOR might be no good, especially if you replaced the coil and plug and still getting no spark at all, olderthan also has a point to check the settings on your valves.
__________________
Roketa GK-01 150cc ENGINE INFO ： Engine type ： CVT,4-stroke Bore*stroke ： 2.3*2.3 inches Tires,front/rear ： 19*7-8/22*11-10 |
|
#5
07-17-2010, 08:01 PM
|
|||
|
|||
|
Get a buddy to hold the spark plug out of the motor attached to the coil with the tip grounded on the motor and you turn it over while he checks for spark if your not sure on the spark(didnt seem by your post you truly checked the spark)
|
|
#6
07-18-2010, 12:38 AM
|
||||
|
||||
|
What he said.
__________________
-JoshMy Ride: ASW Carbide Mods: Dr. Pulley Hit Clutch FMF Slip-On Exhaust No Rev. CDI Uni Air Filter 130 Main jet 1500 RPM main clutch spring 11g sliders 75w Halogen Headlights CARBIDE! |
|
#7
07-18-2010, 09:06 AM
|
||||
|
||||
|
Find someone, in your area, that CAN, diagnose an engine, even a lawn mower, and get a little hands on instruction assistance. Check with a local "tech school" that runs night classes...see if they'd be interested in a one night session of trouble shooting.
__________________
kliff |
|
#10
08-13-2010, 11:06 PM
|
||||
|
||||
|
Another thing to check would be the kill switch(es). If they're the same as the Helix (I am assuming they are) there should be one by the key AND one on the electrical box. Believe me, I've tried starting up my kart only to find the kart only turning over and not sparking because the kill switch was engaged.
|
|
#11
08-14-2010, 06:15 AM
|
|||
|
|||
|
If you got a trailer and feel like a ride I'll fix it for you no charge. I have a full wiring harness thats good with cdi, coils, and all that jazz. We can pull the carb and give it a short soak while we adjust the valves. Then check the spark. If no spark we will use a tester to find the weak link
Your discription really dont help to pin point the problem. Not your fault cause you dont know any better. But as you can see you'll end up with 100 possible causes |
|
|
