|
|
|
|||||||
| Go Kart Engine and Torque Converter Tech Forum for discussing go kart engines and torque converters (Briggs, Tecumseh, Suburu, Comet etc) |
 |
|
|
Thread Tools |
|
#1
10-20-2009, 01:28 PM
|
|||
|
|||
6.5 not starting
ok so basicallly i followed the buggymasters video on youtube to remove the govenor i followed all the steps carefully made sure everything was where it was supposed to be sooo i put it back together and tried to pullstart it and it just kept spinning like there was no compression or very little because u can hear it a little bit so then i tried spinning it by hand and u can hear that it has compression it just turns wicked easy and wont start can anyone help me plz????
|
|
#2
10-20-2009, 01:49 PM
|
||||
|
||||
|
sounds like the can timing is off.
In addition, I would pull the valve cover off (only a couple of bolts) and make sure that the valve action looks correct. This will tell (and show) you if by chance the pushrods came unseated. Pull the valve cover first since that's easiest.
|
|
|
|
