|
|
|
|||||||
| 150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
 |
|
|
Thread Tools |
|
#1
08-25-2010, 07:25 PM
|
|||
|
|||
oil in the intake Carbide 150
My sons kart stopped running over the weekend. I took the filter housing apart and the filter was caked with oil and there was a lot of oil in the intake housing. Why would there be so much oil in the intake?
When I removed the filter the kart started right up. I put an old K&N filter on and it ran like new again. Any help is appreciated... 
|
|
#2
08-25-2010, 07:40 PM
|
||||
|
||||
|
check your tube from valve cover do not put xtra oil in motor only what is supposed to
be in there if your filter was dirty can pull oil from valve cover on my 150 based howhit i run the breather line to my chain guard
__________________
olderthan 2008 tomberline punisher 1500 spring 12g sliders 30mm cv pumper carb uni filter no rev cdi polaris xlt snowmobile shocks for front w/550 magnum springs & blaster fronts on rear and another buggy built working on mods gk-13 white spring 17 gram sliders so far
|
|
#3
08-25-2010, 07:48 PM
|
||||
|
||||
|
Ya oil gets in there through tube that connects to it from valve cover. How old is the carbide?
|
|
#4
08-25-2010, 08:09 PM
|
|||
|
|||
|
less than a month, but my son runs it real hard. I changed the oil after the first 2-3 hours with good quality oil. I didnt change the oil filter however and put a little too much oil in when I changed it. it was slightly over the dip stick marking but I left it alone. The oil now is right in the middle of the markings. Most of the oil I think was a mixture of oil and water.
|
|
|
|
