|
|
|
|||||||
| 150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
|
Thread Tools |
|
#1
10-13-2011, 08:35 PM
|
||||
|
||||
Bought a GY6, have ?'s
I bought this from ebay
 I am building a spiderbox type buggie for my son and I. How do I connect the output shaft to the rear axle gear? What other items will I need to make this engine work? Thanks in advance! |
|
#2
10-13-2011, 08:37 PM
|
||||
|
||||
|
The pic isn't coming through-maybe it's just my computer.So what type engine is it?
|
|
#4
10-13-2011, 09:11 PM
|
||||
|
||||
|
Pic came through!!! BMI sells the standard Howhit (Yerfdog Spiderbox) 13t sprocket, cut a piece of pipe to space out the rest of the distance on the shaft for the nut to fit. If the 13t sprocket isn't the right tooth count I can get you a link to a 14t,15t,16t with the right spline count (19)-this scooter shaft will also let you install the external reverse kit, that shaft is a 1/2" shorter than the ones that came with reverse but it still works. Since it's a Spiderbox type build you can set the axle sprocket accordingly after the engine is installed.BMI may sell the the Spiderbox front wiring harness-on/off switch,start button that plugs right in to your 4 pin outlet.See if they have the stock exhaust pipe too, you can always change the muffler-at least you'll have a pipe to work with that will bolt up to that engine.
Last edited by metalstudman1; 10-13-2011 at 09:16 PM. |
|
|
