|
|
|
|||||||
| Mini Buggy General Discussion General Discussion forum for Mini Buggies. (American Sportworks, HammerHead, Carter, etc) |
|
|
Thread Tools |
|
#1
02-24-2010, 10:23 PM
|
||||
|
||||
Update on the carbide
So, I found out that the teeth on the output shaft of the engine were still there and I'm not going to have to replace that, so, I just bought the replacement parts myself (11g sliders, new fan plate, and new main drive belt). I'll be using the original variator instead of buying a performance one like I had. The parts got here today and I should have the buggy back up and running by tomorrow or Friday. In all of this, there is one question I have. Does anyone know how many foot pounds of force should hold the bolt that holds the fan plate on? Thanks for any info.
__________________
-JoshMy Ride: ASW Carbide Mods: Dr. Pulley Hit Clutch FMF Slip-On Exhaust No Rev. CDI Uni Air Filter 130 Main jet 1500 RPM main clutch spring 11g sliders 75w Halogen Headlights CARBIDE! |
|
#2
02-24-2010, 10:33 PM
|
||||
|
||||
|
You might find that in the service manual that is a sticky thread in the tech section.
Glad you have it figured out. Hope you are back running soon. |
|
#3
02-24-2010, 10:34 PM
|
||||
|
||||
|
Thanks. I hope so too
__________________
-JoshMy Ride: ASW Carbide Mods: Dr. Pulley Hit Clutch FMF Slip-On Exhaust No Rev. CDI Uni Air Filter 130 Main jet 1500 RPM main clutch spring 11g sliders 75w Halogen Headlights CARBIDE! |
|
|
