|
150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
Thread Tools |
#1
|
|||
|
|||
How would you partially gut this Exhaust
Hey Guys,
Debating whether to gut my stock exhaust or buy an aftermarket one. I'm wondering if anybody has gutted this particular one. It's from a 2012 ASW carbide 150cc. Looking inside with a flash light, I can see a plate about 3 inches back from the exhaust exit. This plate has four 3/8" holes in it, and behind the place I can that wire mesh baffle stuff also. Anybody have good results by simply drilling it, or should just the exit hole itself be enlarged? Right now it's 1" wide. |
#2
|
||||
|
||||
I cut the end piece off ripped everything out including the hart . And welded the end piece back on. You need a welder for this. ... or drill a 3/8 hole at 12 oclock 4 and 8 oclock around the outlet. If you want more than drill more holes around in a uniform fashion.
__________________
2. 150cc carters. 1. Baja reaction 150cc dr2 variators Jerseydevil hp. Pipes unifilters gates belts. Yellow main springs hd. Orange coils. |
|
|