BuggyMasters.Com - An On Line Mini Buggy Forum and Go Kart Forum

Go Back   BuggyMasters.Com - An On Line Mini Buggy Forum and Go Kart Forum > General Mini Buggy and Go Kart Forums > Go Kart General Discussion

Go Kart General Discussion Forum for general go kart discussion.

 
 
Thread Tools
  #1  
Old 01-20-2018, 08:02 PM
Michigan Mudd Michigan Mudd is offline
Lurker
 

Join Date: Jan 2018
Posts: 1
Default China made 200cc kart - cant get chain tight

Was only able to find 1 utube video about a similar kart setup https://youtu.be/6ddACfapUQ4

When i did these steps it did very little.

Is it possible for my chain to stretch? And i need to shorten it?
Attached Images
File Type: jpg 20180120_145937.jpg (99.0 KB, 15 views)
  #2  
Old 01-20-2018, 10:11 PM
neo71665 neo71665 is offline
Contributor
 

Join Date: Jun 2017
Posts: 284
Default

Chains are a wear item and stretch. If it is to the point you have to remove links to shorten it then it needs to be replaced. You also need to inspect the sprockets to make sure they are not worn and still in usable shape. If you don't know how to tell post a picture and somebody will be able to.
  #3  
Old 01-21-2018, 11:20 AM
SYCARMS's Avatar
SYCARMS SYCARMS is offline
Supporting Vendor
 

Join Date: Sep 2009
Location: Senatobia, Mississippi
Posts: 3,375
Default

Agree with neo71665. Pull the chain, make sure no links bind. If rusty and or gritty soak overnight in some diesel than clean with either a chain brush or any stiff brush. If there were binding links check to make sure they don't bind. Grab 2 adjoining links and push together and pull away, if any play is observed replace the chain. Check both sprockets for wear. Teeth should not come to a point, they should have flat tips. If pointed replace sprockets. Sprockets and chain will last many miles and years if regularly cleaned and lubed which the majority don't do. Dirt and rust is no friend to chains or sprockets.
  #4  
Old 01-21-2018, 05:39 PM
x-bird's Avatar
x-bird x-bird is offline
Power User
 

Join Date: Oct 2011
Location: Penciltucky
Posts: 2,518
Default

that vid shows a setup very similar to what i replicated with my daughters. The main engine hangar bolt has a nut on top and underneath the plate on the swingarm. you have to loosen the top nut, then go underneath and run the nut on the underside clockwise to move it closer to the engine. Then you can use the adjuster on the right to pull the engine upwards to tighten the chain. If you don't run that underside nut down the shaft, it will not get any tighter.

in the pic below, you can't see the underside nut on the left, its hidden by the tubing.
Attached Images
File Type: jpg s rear.jpg (85.6 KB, 11 views)

Last edited by x-bird; 01-21-2018 at 05:42 PM.
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:42 AM.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.