|
150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
Thread Tools |
#1
|
||||
|
||||
yerf dog arms?
ok as most of u have seen me pics have a question since i have the uneven a-arms 1st generation. If i where to switch to the 3rd generation arms the stock tie rods will still reach the spindle correct? on top of that have any of you switched the tie rod ball joints to heim since that would be easy to change out? i guess u would need a adjustable heim joint though to fix the toe in and toe out? sorry its a 3206 spyder box for some who havent seen the pics
|
#2
|
||||
|
||||
Are you reading any other current threads?!!!!! The steering arms/tie-rods for the even & un-even A-arms are the same length.
Here's x-bird's design starting @ about post #360 (his first design)thru current final design: http://www.buggymasters.com/forum/sh...3738#post23738 Here's my design starting @ post #58 http://www.buggymasters.com/forum/showthread.php?t=1159 |
#3
|
||||
|
||||
of course im reading alot of the threads im looking to keep my rack and just put the longer generation 3 arms on top while using the stock tie rod arms u guys have crazy mods done by switching the front end completely
|
#4
|
||||
|
||||
Your question/statement is why I asked if you'd been reading!!!!! The 2 links I gave you dealt with your specific question/statement.
|
#5
|
||||
|
||||
Heim i use MMF-M12 ... I get it through a shop, don't think they sell direct, but that's the thread and pitch you'll need.
http://aurora.thomasnet.com/results/...d=&backtoname= High misalignment spacer that fits them ... http://www.midwestcontrol.com/part.php?id=2506 Last edited by x-bird; 05-01-2012 at 10:54 PM. |
|
|