|
|
|
|||||||
| 150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
|
Thread Tools |
|
#1
06-02-2015, 05:01 PM
|
|||
|
|||
Spiderbox starter issues
Hello all
We are new to our spiderbox. It is not starting when pressing the red button. I have replaced a few of the electrical parts but nothing has helped. How do you test the starter. I think I am getting voltage to the starter but it Does nothing. |
|
#2
06-02-2015, 05:52 PM
|
||||
|
||||
|
one trick i use sometimes is make connect a wire from the battery hot wire on one side and attatch the other end to the wire that is on the starter. that will tell you if you have a bad starter if it doesnt spin. have you checked with a voltage meter if any current is getting through to the starter? you probably have a bad solenoid or ignition switch if you know all the wiring is good still and it does spin when you do the trick above.
|
|
#4
06-02-2015, 10:19 PM
|
||||
|
||||
|
Make sure you have a solid ground. Broke mine and the start button being pressed did zilch.
Found the ground wire broke from the engine to the cradle connection. Check yours
__________________
My Yerban assault vehicle: 2.2mm stroker crank, 62mm Nikasil cyl, Taida large vavle head, American made valve springs, ported intake manifold, TM 28mm carb, stock CDI, Bando coil, TK exhaust, stock CVT except for the 14g sliders, 13/40 internal gears, 16T drive, 31T axle sprocket, 22" rear tires, and ONE BIG POTATO CANNON mounted on top.......... |
|
|
