|
|
|
#1
09-19-2010, 07:12 PM
|
||||
|
||||
Tecumseh OHH EXHAUST
Hey There AllI am wonderin is there any available,
or could i make it myself , a exhaust header for these ohh go karts I have . I know its tapped 3/4 NPT so i could fab up anything i basically wanted but anyone know of like a exhaust to top it with or can you even ? without burnin' valves , or losing my back pressure As always Thanks
__________________
2004 Yerf DOG 150CC GY6 NGK PLUG CDI UPGRADE HIGH OUTPUT IGNITION COIL 125 JET GUTTED EXHAUST RED NECK UNI STYLE INTAKE WITH PRE FILTER New front end parts : SPINDLES BALL JOINTS TIE ROD ENDS http://anysoldier.com Support our Troops send them a card letter or magazine subscription candy playing cards twizzlers gum homemade cookies |
|
#2
09-19-2010, 08:07 PM
|
||||
|
||||
|
You could probably hook up a candy cane header of some kind. The Tecumseh's just don't seem to hold up as well as a briggs. If I remember right, they have an aluminum sleeve or something which is why they are typically rated for about 150 hours and then their done.
|
|
#3
09-30-2010, 03:40 PM
|
||||
|
||||
|
Have you known anyone who used one on these engines or anyone else out there ever tried a header pipe on a ridgid go kart tecumseh motor?
__________________
2004 Yerf DOG 150CC GY6 NGK PLUG CDI UPGRADE HIGH OUTPUT IGNITION COIL 125 JET GUTTED EXHAUST RED NECK UNI STYLE INTAKE WITH PRE FILTER New front end parts : SPINDLES BALL JOINTS TIE ROD ENDS http://anysoldier.com Support our Troops send them a card letter or magazine subscription candy playing cards twizzlers gum homemade cookies |
|
#4
09-30-2010, 07:30 PM
|
||||
|
||||
|
I've made many different exhausts for the 6hp and 6.5hp Tecumseh and the "J" or candy cane that Buggymaster suggested seems to produce the best performance.I believe the bend produces the right amount of back pressure,You get lots of noise (sounds stronger) and slightly more RPM's.I've timed laps with stock and homemade pipes to find out which worked best. I've capped the pipes with a large lawnmower muffler to reduce the noise level. I found as long as the pipe is 12"+ long it didn't backfire too bad and didn't burn valves.I have 4 Tecumseh engines that have run for over 500 hrs with NO problems.The Batman kit does give you a good gain of power but in my opinion it's TOO small a bang for your buck.
|
|
#5
09-30-2010, 09:10 PM
|
||||
|
||||
|
Excellent Just the info I was looking for . Thank You
__________________
2004 Yerf DOG 150CC GY6 NGK PLUG CDI UPGRADE HIGH OUTPUT IGNITION COIL 125 JET GUTTED EXHAUST RED NECK UNI STYLE INTAKE WITH PRE FILTER New front end parts : SPINDLES BALL JOINTS TIE ROD ENDS http://anysoldier.com Support our Troops send them a card letter or magazine subscription candy playing cards twizzlers gum homemade cookies |
|
|
