quick release steering wheel ?

[jmansracerocket]

I was trying to look for a quick release steering wheel setup for the hammerhead, it will just make getting in and out a lot easier. The stock steering wheel is 12inch diameter and the shaft is a 3 bolt design that holds the wheel on. I tried tons of research cant seem to find what I'm looking for, if anyone can shoot me in the right direction that would be great.

[Sngmac]

I got mine from dansperformanceparts.com. They have all different ones but I got the basic one 29.99. It is a three hole mounting hub. I've ordered a bunch of parts from him and the quality has been good.
Steve

[SYCARMS]

Jegs will also have them.

[jmansracerocket]

i just need to go out and measure the steering shaft on the hammerhead, I think its 3/4 of an inch, because I see you have to weld the sleeve on the shaft.

[SYCARMS]

I got mine from either jegs or summit and did not have to weld anything.

[jmansracerocket]

Originally Posted by SYCARMS

I got mine from either jegs or summit and did not have to weld anything.

U most likely have a splined shaft then?

[SYCARMS]

No it bolts to the steering wheel couplet.

[jmansracerocket]

Originally Posted by SYCARMS

No it bolts to the steering wheel couplet.

hard to find the correct one, curious to which one u have then.

[jmansracerocket]

http://www.dansperformanceparts.com/...ized-each.html

that's the one I was looking at, I would have to just cut the flange off, and then weld on the hex insert.

[SYCARMS]

I'll look on my buggy tomorrow to see if any identification.

[jmansracerocket]

Just took a measurement the steering wheel shaft is 7/8 thick

[Sngmac]

Dan's performance has a 7/8" one that should work

http://www.dansperformanceparts.com/...ing-7-8in.html

[Sngmac]

Or this one

http://www.dansperformanceparts.com/...ized-each.html

[jmansracerocket]

Ty steve, dam wish i ordered the black hub, i already ordered it in the afternoon.