|
Mini Buggy General Discussion General Discussion forum for Mini Buggies. (American Sportworks, HammerHead, Carter, etc) |
|
Thread Tools |
#1
|
|||
|
|||
Baja Dune 150 - rear bounces non stop
So I have been working on a baja dune 150 and it rode great. parked it for a while (blown starter) and finally got it fixed up again. However, going down the road the whole thing bounces like a rubber ball! Boing, Boing, Boing, Boing, etc. Very annoying - what happened? Granted - I got it in rough shape for $200, could the shocks have up and died? I am no lightweight - 6'5" 240lb so I could believe that I killed the shocks. Any other thoughts?
Oh and I wired in a sweet 20" LED light bar. Thanks, Joe |
#2
|
||||
|
||||
stock shocks aren't the best, but not horrible, and if the buggy sat outside that makes it worse, also depends on your tires also, u might have adjustable shocks, you can turn the preload to a softer setting.
also tire air pressure plays a role.
__________________
Hammer head Single seater know as herbie under construction Aluminum fuel tank, aluminum wheels, custom fuel/cargo rack, entire rewire, trail tech vapor, ported big valve head, a12camshaft, 12 gram sliders, straight intake, kirkey wide seat, front end extension. 4 point harness, welded cage. Hammerhead exhaust. Blade Single Seater Restore welded cage, engine build, new wiring harness/electric box, spun aluminum fuel tank. |
#3
|
|||
|
|||
Definitely sat outside. Tires were low and I added air just before taking a spin. Tires are original - Lord knows how old they are! But they have decent tread. Maybe flat spotting in the cold?
|
#4
|
||||
|
||||
flat spots will cause a improper ride.
__________________
Hammer head Single seater know as herbie under construction Aluminum fuel tank, aluminum wheels, custom fuel/cargo rack, entire rewire, trail tech vapor, ported big valve head, a12camshaft, 12 gram sliders, straight intake, kirkey wide seat, front end extension. 4 point harness, welded cage. Hammerhead exhaust. Blade Single Seater Restore welded cage, engine build, new wiring harness/electric box, spun aluminum fuel tank. |
#5
|
||||
|
||||
Check to see if the axle is bent.
__________________
My Yerban assault vehicle: 2.2mm stroker crank, 62mm Nikasil cyl, Taida large vavle head, American made valve springs, ported intake manifold, TM 28mm carb, stock CDI, Bando coil, TK exhaust, stock CVT except for the 14g sliders, 13/40 internal gears, 16T drive, 31T axle sprocket, 22" rear tires, and ONE BIG POTATO CANNON mounted on top.......... |
#6
|
|||
|
|||
On that same line, check the tightness on you nuts for your hubs and wheels.
|
|
|