|
|
|
|||||||
| 250cc and Above Engine Tech Technical Discussion Forum for 250cc and up Engines |
 |
|
|
Thread Tools |
|
#1
04-18-2013, 01:55 PM
|
|||
|
|||
Dual Battery
Hi all, I have a XYKD 260-1, 260cc engine and I've made some small modifications. What I want to do is add another battery to run my lights and my winch. I have a battery which is exactly the same as the main and I have a 70 amp isolator. My question is this, I can't figure out which wire charges the battery when the engine is running. There's only one wire that goes to the battery, do I use that same cable to go to the alternator connection on the isolator? Working with a basic motorcycle engine is new to me. Does anyone have any suggestions? Thanks again.
|
|
#2
04-19-2013, 11:06 AM
|
||||
|
||||
|
I would just run a truck size battery for ur winch and extra. Lites and accessories by itself with a switch.and charge it after every use.. don't mess with your buggies battery system. I say this cause I'm no electrician.
__________________
2. 150cc carters. 1. Baja reaction 150cc dr2 variators Jerseydevil hp. Pipes unifilters gates belts. Yellow main springs hd. Orange coils.
|
|
#3
04-19-2013, 03:57 PM
|
||||
|
||||
|
Agree with Eddie. The greater load you put on the stator the more power you lose, and the greater your chances of burning it up. I think you would fare better hauling the big battery than you would trying to charge two batteries at once.
__________________
MXR TrailBender 160R SYC Perf head P&P,Matched intake and exhaust, A12 cam, Orange CDI & coil, Motorio pulley, 115mm Variator and lightweight drive face,11gm Sliders, UNI, modded muffler + 200 horsepower  http://www.youtube.com/watch?v=3hx-hEWl10c I'll take your insults as compliments and blame it on your lack of intelligence.
|
|
|
|
