|
|
|
#1
03-29-2012, 08:33 PM
|
||||
|
||||
Lubing Axle Bearings
I did a search, no luck. Anyone know how to lube these7790-31887.jpg
They got three holes in the race but once you put them in the retainers you can't grease them.
__________________
If the only tool you have is a hammer, Then all your problems look like nails. |
|
#2
03-29-2012, 10:19 PM
|
||||
|
||||
|
When this bearing is in a pillar block (large equipment & HVAC systems) they have a hole in the top of the pillar for oil- maybe you need to add one on your carrier
Last edited by metalstudman1; 03-29-2012 at 11:31 PM. |
|
#5
03-30-2012, 03:17 PM
|
||||
|
||||
|
They came in a kit with triangular metal plates with square holes. Can't figure where a zerk would go. I lubed them up before installing them.
__________________
If the only tool you have is a hammer, Then all your problems look like nails. |
|
#7
05-04-2012, 08:04 AM
|
||||
|
||||
|
Just an update. I got some of the Gman bearing protectors for the axle bearings. You need to remove the metal shield from one side of the bearing and install the gman piece in its place. They are molded urethane so the od needs to be sized to fit the bearing.
Since it allowss full access to the ball bearings, I decided to pack them with hi temp grease.
__________________
If the only tool you have is a hammer, Then all your problems look like nails. |
|
|
