As many may have read I converted a Dazon 250 to run on a Yamaha snowmobile engine and then the engine was destroyed. The new owner wants the original engine put back in, so I have all the pieces up for sale now. This setup allows you to connect the secondary clutch directly to a gearbox without running a jackshaft. This setup cost me a lot more than I want to think however best offer gets it. You pay shipping of course.
This setup could also be used as a short jack shaft, if you mounted a geat to the end that mated to the gearbox. Saft is 4140 steel and housing is schedule 80 tubing.
Many images and the process as well as images of the gear box and all the pieces please see this post:
http://www.buggymasters.com/forum/showthread.php?t=2083
Setup includes the following:
Primary Comet 102C clutch w/ 2 sets of weights & 2 springs (2400 & 5400 rpm)
Secondary clutch w/ 2 springs (stock & same as Honda FL350)
(2) used belts, one is almost new.
Custom machined shaft and mount with 3 or 4 sealed bearings inside.
04-15-2012, 01:17 AM
Snowmobile Engine Conversion Kit
