BuggyMasters.Com - An On Line Mini Buggy Forum and Go Kart Forum

Go Back   BuggyMasters.Com - An On Line Mini Buggy Forum and Go Kart Forum > Technical Discussions > 150cc GY6 and Under Engine Tech

150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum

 
 
Thread Tools
  #1  
Old 08-13-2020, 10:04 PM
Papa Tom Papa Tom is offline
Lurker
 

Join Date: Jun 2020
Location: Kansas City
Posts: 15
Default Gy6

Went to check the compression on this engine as it smokes a bit. Threads didn't seem right so used the rubber cone and pressed it on the spark plug hole. Came out about 100 - 102.

Put the plug back in and felt soft tightening it up. Tried to start it and POP! shot the plug right out. Got parts coming in from Kart Mart where the buggy originally came from and hoping to pick up Friday. Will be a first tearing into one of these engines.
Attached Images
File Type: jpg IMG_9249.jpg (98.2 KB, 4 views)
File Type: jpg IMG_9243.jpg (85.4 KB, 3 views)
  #2  
Old 08-16-2020, 11:39 PM
plee911's Avatar
plee911 plee911 is offline
Contributor
 

Join Date: Feb 2018
Location: Arizona
Posts: 173
Default

Its not to bad just make sure you set your timing before breaking it down. Other than that is easy. One tip dont use any coatings on the lower jug gasket and make sure your torque it correctly. Speaking from experience on this one.
__________________
Where there is a red neck there is a way.
  #3  
Old 08-17-2020, 06:02 PM
Papa Tom Papa Tom is offline
Lurker
 

Join Date: Jun 2020
Location: Kansas City
Posts: 15
Default

Okay,

I started the tear down and I found that there was and air leak buy the carb. Picture attached. Must be why it would not idle well.


https://photos.app.goo.gl/DKCgWvPThggr6gyu7

Last edited by Papa Tom; 08-17-2020 at 06:12 PM.
  #4  
Old 08-17-2020, 11:16 PM
plee911's Avatar
plee911 plee911 is offline
Contributor
 

Join Date: Feb 2018
Location: Arizona
Posts: 173
Default

yea that would cause problems through the whole throttle range for sure. Less at WOT because only so much air can pass through but definitely a problem that needs fixed
__________________
Where there is a red neck there is a way.
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:22 PM.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.