BuggyMasters.Com - An On Line Mini Buggy Forum and Go Kart Forum

Go Back   BuggyMasters.Com - An On Line Mini Buggy Forum and Go Kart Forum > Technical Discussions > 150cc GY6 and Under Engine Tech

150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum

 
 
Thread Tools
  #1  
Old 11-25-2011, 05:58 AM
wsconner wsconner is offline
Lurker
 

Join Date: Nov 2011
Posts: 5
Default idles for a minute then stalls

I have a Quantum by American Sportsworks with 150cc GY6 engine. We hadn't run it is a couple of months, but it did have fuel treatment. It starts up and idles for 15-30 seconds, but as soon as we apply throttle it dies and then becomes harder to start. We have not been able to get it to run. Fuel filter looks ok. Any other ideas?
Many thanks.
  #2  
Old 11-27-2011, 06:05 AM
wsconner wsconner is offline
Lurker
 

Join Date: Nov 2011
Posts: 5
Default follow up

So I tried a few other steps to troubleshoot, but still have same problem. Engine will run for 30-60 seconds, then dies. I hear a click right before it dies. When it's idling, as soon as you give it throttle, it clicks and stops.

1. Checked air filter--clean
2. pulled fuel filter and petcock. I thought there was a clog in the petcock because when I removed the hose that goes to the fuel filter, no gas came out. In hindsight, I presume there needs to be a vacuum (the hose coming from the bottom of the petcock) to create suction to draw the fuel out. regardless, I blew compressed air through both the filter and petcock, but still had the same problem.

Any other theories? I have a spark, and the engine does run, but have not tried a new plug yet.

thanks for any advice.
  #3  
Old 11-27-2011, 11:46 AM
BuggyMaster's Avatar
BuggyMaster BuggyMaster is offline
Administrator
 

Join Date: Jul 2009
Posts: 2,312
Default

Does it shut off abruptly or act like it runs out of gas or something?
  #4  
Old 11-27-2011, 12:38 PM
wsconner wsconner is offline
Lurker
 

Join Date: Nov 2011
Posts: 5
Default

it's more like it sputters, then dies. It sounds like a fuel issue, but I can't seem to figure out where it is clogged. If it needs a vacuum to pull fuel through the hose, I am not sure how to test for a vacuum leak. I was going to rig a separate fuel source just to try it out. also thought about removing the petcock entirely, but not sure that is good for the engine (I assume it meters the flow of fuel).
  #5  
Old 11-27-2011, 12:43 PM
BuggyMaster's Avatar
BuggyMaster BuggyMaster is offline
Administrator
 

Join Date: Jul 2009
Posts: 2,312
Default

do you have some spray type carb cleaner?

If so, have someone in the buggy. Take off the air box completely. Kinda give it gas to where normally it would die and when they tap the gas, give it a shot of the carb cleaner. If it grabs and revs like it should when you give it that shot, then you know you have a starvation issue and you can make adjustments from there. You need to know if it is starving or choking as a matter of fact before you can decide which way to handle it.

Don't have your face down there when you are giving it that shot either in case it back fires.
  #6  
Old 12-01-2011, 10:11 PM
townie townie is offline
Lurker
 

Join Date: Oct 2011
Location: Toronto Ontario Canada
Posts: 8
Default

my buggy was doing the same thing and i drilled a hole in the diaphram in the petcock and then cap the vacuum line at each end then the fuel will flow. ethanol in the gas wreckes the diaphram hope that helps
  #7  
Old 12-02-2011, 04:17 PM
wsconner wsconner is offline
Lurker
 

Join Date: Nov 2011
Posts: 5
Default

so I tried a separate fuel source today, because I was fairly convinced the petcock was clogged somewhat even after blowing air through it. It had the same exact problems, with and without the vacuum tube plugged. So I am assuming the is an issue in the carb vacuum. will advise once I know more...
  #8  
Old 12-03-2011, 03:18 PM
townie townie is offline
Lurker
 

Join Date: Oct 2011
Location: Toronto Ontario Canada
Posts: 8
Default

good luck i hope you figure it out sooner than later
  #9  
Old 01-02-2012, 09:42 AM
wsconner wsconner is offline
Lurker
 

Join Date: Nov 2011
Posts: 5
Default Solved?

before I pulled carb to clean and/or install new one, I figured I would give it one last go from the top. I found a crack in the hose that leads from the crank case to the exhaust, and once I fixed that, I was able to give it throttle without it dying. Idle appears to be off a bit, but I think I can fine tune that.

after a lot of research, it appears these GY6 engine vacuum systems are simple but finicky. I think I am going to remove the petcock and go with a direct source system (and cap that part of the vacuum).

Also considering some performance uprades-- are the perf carbs worth it on these engiines? how about perf CDI's and coils?
Thanks.
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:57 PM.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.