BuggyMasters.Com - An On Line Mini Buggy Forum and Go Kart Forum

Go Back   BuggyMasters.Com - An On Line Mini Buggy Forum and Go Kart Forum > Technical Discussions > Go Kart Engine and Torque Converter Tech

Go Kart Engine and Torque Converter Tech Forum for discussing go kart engines and torque converters (Briggs, Tecumseh, Suburu, Comet etc)

Reply
 
Thread Tools
  #1  
Old 09-08-2012, 12:00 PM
tybic tybic is offline
Lite Contributor
 

Join Date: Oct 2010
Location: Southern Illinois
Posts: 34
Default Procedure for replacing bearings in cvt clutch

Ok I have a Quantum Carbie 7150 150cc GY6.
It has shredded the original belt and the two replacement belts (1 per day).
Coworker suggest complete disassembly of variator (which was installed new prior to two replacement belts shredding) and clutch for residual belt parts. Did not find any belt parts but the outer bearing in the clutch is not smooth and needs replaced. I have the the two pullies apart but cannot get to the bearing on the inside of shaft held by snap ring. What is the procedure for this? Also part numbers for the two clutch bearings would be extremely helpful! Thanks guys
Reply With Quote
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:05 AM.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.