BuggyMasters.Com - An On Line Mini Buggy Forum and Go Kart Forum

Go Back   BuggyMasters.Com - An On Line Mini Buggy Forum and Go Kart Forum > Technical Discussions > Other tech issues

Other tech issues For all other technical issues. Think frame, suspension, steering, brakes, etc

Reply
 
Thread Tools
  #1  
Old 10-14-2017, 01:02 PM
mrbeggs mrbeggs is offline
Lurker
 

Join Date: Oct 2017
Posts: 7
Default Chinese buggy 150cc wont start

I need some help on this issue.

At first I had engine case filling up with gas...fixed that problem by changing gas tank fuel valve assembly and after putting on a new carb & manifold.

Now the cart wont start...I have proper oil level...gas...and spark.
The motor turns over just wont catch.......could the oil safety sending unit get screwed up with that gas that stayed inside the case ???

Any ideas of what else I can check ?

Obviously Im posting due to being mechanically challenged !
Reply With Quote
  #2  
Old 10-14-2017, 07:47 PM
BuggyMaster's Avatar
BuggyMaster BuggyMaster is offline
Administrator
 

Join Date: Jul 2009
Posts: 2,311
Default

If the oil switch was a problem then you wouldn’t have spark. Did it run before?
Reply With Quote
  #3  
Old 10-15-2017, 09:32 AM
mrbeggs mrbeggs is offline
Lurker
 

Join Date: Oct 2017
Posts: 7
Default

Yes it ran before.

I put new carb & manifold and ran it a few minutes but it idled kind of high.

Then I went to check oil before my son ran it and gas came gushing out of oil filler.

It sounded good when idling....ordered new gas tank valve assembly...let case drip dry a few days and cleaned plug.

Now it just turns over but wont start.....It sounds healthy while cranking so
I'm guessing I didn't hurt it too bad.

Any other ideas I can try ???

Thanks
Reply With Quote
  #4  
Old 10-15-2017, 10:11 AM
BuggyMaster's Avatar
BuggyMaster BuggyMaster is offline
Administrator
 

Join Date: Jul 2009
Posts: 2,311
Default

Get a can of carburetor cleaner and pull the air box off. Have someone turn it over and when they do give the carb a little shot of carb cleaner. If it fires, then you know you have a fuel issue. Post back what happens.
Reply With Quote
  #5  
Old 10-15-2017, 06:53 PM
SYCARMS's Avatar
SYCARMS SYCARMS is offline
Supporting Vendor
 

Join Date: Sep 2009
Location: Senatobia, Mississippi
Posts: 3,375
Default

What buggy and engine do you have?
Reply With Quote
  #6  
Old 10-17-2017, 04:37 PM
mrbeggs mrbeggs is offline
Lurker
 

Join Date: Oct 2017
Posts: 7
Default

Chinese Buggy 150cc I believe.....Z-2150R
Reply With Quote
  #7  
Old 10-17-2017, 04:44 PM
mrbeggs mrbeggs is offline
Lurker
 

Join Date: Oct 2017
Posts: 7
Default

tried that and no go....it makes a slight turn like it wants to kick only for a sec and then continues to just turn....
Ok took off new carbeurator again and went through and cleaned thoroughly..checked jets m float...Even went through old carb and did the same...no debris or blockage.
Have not checked the automatic choke needles but doubtful both can be bad...who knows.
Tried with n without choke connected...still have plenty of spark....
I'm sure its something stupid but its got me so far
Reply With Quote
  #8  
Old 10-17-2017, 04:45 PM
mrbeggs mrbeggs is offline
Lurker
 

Join Date: Oct 2017
Posts: 7
Default

also gas is pumping to the carb.....can see thru filter as turning over
Reply With Quote
  #9  
Old 10-17-2017, 06:18 PM
SYCARMS's Avatar
SYCARMS SYCARMS is offline
Supporting Vendor
 

Join Date: Sep 2009
Location: Senatobia, Mississippi
Posts: 3,375
Default

What color is the spark? Have you tried to start with staring fluid?
Reply With Quote
  #10  
Old 10-18-2017, 04:53 PM
mrbeggs mrbeggs is offline
Lurker
 

Join Date: Oct 2017
Posts: 7
Default

tried starter fluid.....spark looks blue/white ? bad eyesight.........clean plug....no start
what else can I try ? .....stick a dynamite.....lol
Reply With Quote
  #11  
Old 10-18-2017, 04:57 PM
mrbeggs mrbeggs is offline
Lurker
 

Join Date: Oct 2017
Posts: 7
Default

Please excuse my ignorance.....are you positive it wouldnt have spark or start if my oil safety sensor went bad ???

Sorry had to ask.......just frustrated as heck
Reply With Quote
  #12  
Old 10-24-2017, 10:41 AM
SYCARMS's Avatar
SYCARMS SYCARMS is offline
Supporting Vendor
 

Join Date: Sep 2009
Location: Senatobia, Mississippi
Posts: 3,375
Default

Have you run a compression test on the engine yet?
Reply With Quote
  #13  
Old 10-24-2017, 03:10 PM
neo71665 neo71665 is offline
Contributor
 

Join Date: Jun 2017
Posts: 284
Default

Yeah make sure you have compression. Running it with gas thinned oil will wreck the engine.
Reply With Quote
  #14  
Old 10-25-2017, 10:18 AM
SYCARMS's Avatar
SYCARMS SYCARMS is offline
Supporting Vendor
 

Join Date: Sep 2009
Location: Senatobia, Mississippi
Posts: 3,375
Default

Well it won't exactly ruin the engine but will sure wear out rings and cylinder depending on how long it was run with fuel in the oil. But if the rings are worn it will most likely smoke.
Reply With Quote
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:18 PM.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.