|
150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
Thread Tools |
#1
|
|||
|
|||
Bugs down at full throttle
this go kart it has been sitting for about a year and now every time i punch the gas it bugs down, has a severe lack of power and it dies. i have removed and clean the carb, adjusted it and put new fuel in it. i dont know what to do any more, any suggestions?
|
#2
|
||||
|
||||
welcome to the group-look for leak around intake-if you have to reclean carb use a breadtie thru jets after cleaning hold up to light and make sure you can see thru them
__________________
olderthan 2008 tomberline punisher 1500 spring 12g sliders 30mm cv pumper carb uni filter no rev cdi polaris xlt snowmobile shocks for front w/550 magnum springs & blaster fronts on rear and another buggy built working on mods gk-13 white spring 17 gram sliders so far |
#3
|
|||
|
|||
thanks for your help, there was no leaks arround the intake i used compressed air to blow the jets ans still does the same thing, somebody told me to check the timing on it, do you know where i can find a repair manual for this engine?
|
#4
|
||||
|
||||
Yeah, I was going to say it sounds like a dirty or gunkey carb. It could also be that your carb is not jetted properly.
__________________
-JoshMy Ride: ASW Carbide Mods: Dr. Pulley Hit Clutch FMF Slip-On Exhaust No Rev. CDI Uni Air Filter 130 Main jet 1500 RPM main clutch spring 11g sliders 75w Halogen Headlights CARBIDE! |
#5
|
||||
|
||||
look in the manual section
__________________
olderthan 2008 tomberline punisher 1500 spring 12g sliders 30mm cv pumper carb uni filter no rev cdi polaris xlt snowmobile shocks for front w/550 magnum springs & blaster fronts on rear and another buggy built working on mods gk-13 white spring 17 gram sliders so far |
#6
|
||||
|
||||
For?
__________________
-JoshMy Ride: ASW Carbide Mods: Dr. Pulley Hit Clutch FMF Slip-On Exhaust No Rev. CDI Uni Air Filter 130 Main jet 1500 RPM main clutch spring 11g sliders 75w Halogen Headlights CARBIDE! |
|
|