|
150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
Thread Tools |
#1
|
||||
|
||||
Starting my Yerf 150
I just finished putting my buggy back together after painting it. The new picture is up. But after doing this, it will not start back up. Turns over and everything, just dosent start. Anyone want to help me with this? Its sucking gas too. What could it be???? Dont want to have done all that work and my buggy not work. Very disappointing.
__________________
Sheckells MAV#29 |
#2
|
||||
|
||||
it may be a ground.does it have spark?
__________________
http://www.youtube.com/watch?v=IUgir...ature=g-t=2668 FABRICATION ITS HARDER THAN YOU THINK |
#3
|
||||
|
||||
Ill screw with it tomorrow, right now im going to sleep. Ill let you know how it goes tomorrow.
__________________
Sheckells MAV#29 |
#4
|
||||
|
||||
lol
__________________
MY HELIX -20' maxxis tires -1 1/2in.UNI air filter -gutted exaust -extended lugs -headlights -reflectors -my stickers -adjusted suspension -ground out hubs (to fit on the tires) helix 150 |
#5
|
||||
|
||||
did u accidentally flir flop the gas/vacuum lines? same mistake i made, did the exact thing. itll run terribly if u feather the throttle while u try to start it, but only if its electric start
__________________
CARTER 150 TALON DLX REDNECK INTAKE AND THATS ALL!!! SUGGEST MODS!! |
#6
|
||||
|
||||
That's exactly what I was going to say. If you have the type of petcock that has two lines going to it, the top one will be your fuel supply and the bottom is what goes to the vacuum source on the carb.
|
#7
|
||||
|
||||
I was going to say what roysheepdog said, make sure you have a spark.
__________________
-JoshMy Ride: ASW Carbide Mods: Dr. Pulley Hit Clutch FMF Slip-On Exhaust No Rev. CDI Uni Air Filter 130 Main jet 1500 RPM main clutch spring 11g sliders 75w Halogen Headlights CARBIDE! |
|
|