|
|
|
|||||||
| Mini Buggy General Discussion General Discussion forum for Mini Buggies. (American Sportworks, HammerHead, Carter, etc) |
 |
|
|
Thread Tools |
|
#1
11-15-2010, 10:43 AM
|
|||
|
|||
Starter Question
I just acquired a Helix 150. Being new to these machines, I wonder if someone can enlighten me on the proper operation of the start switch. On my buggy, the start switch has only two positions, off and start. That means the starter motor runs any time the switch is not in the off position. I have reviewed the owners manual, but have not found the answer to this question. Can someone please comment.
Thanks, Viper8yt 
|
|
#2
11-16-2010, 12:01 PM
|
||||
|
||||
|
Are both of the kill switches off? And did you try starting it like a car? Turn the key past the run from the stop?
__________________
-JoshMy Ride: ASW Carbide Mods: Dr. Pulley Hit Clutch FMF Slip-On Exhaust No Rev. CDI Uni Air Filter 130 Main jet 1500 RPM main clutch spring 11g sliders 75w Halogen Headlights CARBIDE!
|
|
#3
11-16-2010, 03:50 PM
|
|||
|
|||
|
Starter Question
I have no problem starting the engine, and yes both of the kill switches are on. The issue is with the keyed start switch. It only has two positions, off and start. The typical start switch has three, off, on and start. I believe there is either a problem with the switch, or someone has installed the incorrect switch. I am simply trying to determine what is correct for the buggy.
Thanks
|
|
#4
11-17-2010, 08:33 AM
|
||||
|
||||
|
I don't know. Anyone else on the forum want to pitch in?
__________________
-JoshMy Ride: ASW Carbide Mods: Dr. Pulley Hit Clutch FMF Slip-On Exhaust No Rev. CDI Uni Air Filter 130 Main jet 1500 RPM main clutch spring 11g sliders 75w Halogen Headlights CARBIDE!
|
|
#6
11-18-2010, 09:09 PM
|
||||
|
||||
|
On the helix, it is a three position. I'd say that if you only have two, you are correct and someone put the wrong switch in.
|
|
#7
11-18-2010, 09:51 PM
|
||||
|
||||
|
But the key doesn't stay in the third position.
__________________
-JoshMy Ride: ASW Carbide Mods: Dr. Pulley Hit Clutch FMF Slip-On Exhaust No Rev. CDI Uni Air Filter 130 Main jet 1500 RPM main clutch spring 11g sliders 75w Halogen Headlights CARBIDE!
|
|
#8
12-23-2010, 01:29 AM
|
||||
|
||||
|
When you turn the key to start and the engine starts. Does it stay in the start position? How do you kill the engine? By turning the switch to 'off' position or by using kill switches?
__________________
2006 HH150.....kinda prodigy vari/clutch 11g Rollers/Yellow Main White Brothers Performance Pipe/No Rev CDI/Hot Coil Stroker Crank/BB 180 kit Mikuni VM28 - 35 Pilot - 140 Main A12 cam blaster shocks x4 vapor speedo
|
|
|
|
