|
|
|
|||||||
| 150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
|
Thread Tools |
|
#1
07-15-2012, 03:41 PM
|
||||
|
||||
bad clutch on a carbide 150
How do you know when your clutch is bad.I have a carbide 150,when you put it to reverse or drive,anbd when you give it gas it rev's up just bit bit before it grab,butwhen it grab its very jerky and grabs hard.Would that be the clutch or maybe the shifter cable not adjusted right.IDK
__________________
 04 yerf 3206rag top  uni filter redneck intake 125 jet 16.5x6.5x8 fronts 21x11x10 holeshots on itp's coming soon 10g roller 1500rpm spring |
|
#2
07-15-2012, 09:58 PM
|
||||
|
||||
|
Sounds more like a flat spots on the rollers. Most clutches I've seen that were bad were blue from over-heating.
|
|
#3
07-15-2012, 10:57 PM
|
||||
|
||||
|
That would be a easy fix.i have to open her up a take a look,thanks for the tip.
__________________
04 yerf 3206rag top uni filter redneck intake 125 jet 16.5x6.5x8 fronts 21x11x10 holeshots on itp's coming soon 10g roller 1500rpm spring |
|
#4
07-16-2012, 12:45 AM
|
||||
|
||||
|
Also it could be the cable from the gearbox, most of the time you can hear it jerking from the gearbox, Just pay attention to it next time.
__________________
T.J. Yerfdog Spiderbox, Uni Type air filter with 6" intake, 130 jet, Orange no-rev limit cdi, Red coil, iridium plug, 1500rpm clutch springs, 1500rpm contra spring, 13g sliders, 22" rears, 21" fronts, aftermarket reverse installed, and Trailtech Vapor. |
|
|
