|
|
|
|||||||
| Mini Buggy General Discussion General Discussion forum for Mini Buggies. (American Sportworks, HammerHead, Carter, etc) |
 |
|
|
Thread Tools |
|
#1
02-02-2015, 07:04 PM
|
|||
|
|||
slip differential axle
Has anyone put an axle on that has a slip differential? I have a carbide 150 that I use on the street and would like to use a slip differential to prevent the tires from getting torn up on corners.
Thank you for any information you may provide. 
|
|
#2
02-02-2015, 08:01 PM
|
||||
|
||||
 it'll suck in the loose stuff and climbing.
__________________
"LUCIFER" JOYNER JD400, CROSSHAMMER 250R, YERF GX150, CROSSFIRE MBX150, BMS 800V-TWIN '16 RZR 900s , '17 ACE 900XC, '99KX250, '94 KDX200, '18 SSR SR170TX
|
|
#4
02-04-2015, 11:18 AM
|
||||
|
||||
|
Skip the first half of the below thread. you could go this route and not weld up the spider gears like i did. You will have to change to sealed bearings for the carrier since the center section is wide open. This rear swingarm is now on another project buggy that's near completion. Note though, that this does NOT created a limited slip axle.
http://buggymasters.com/forum/showthread.php?t=2965
|
|
|
|
