|
|
|
|||||||
| Mini Buggy General Discussion General Discussion forum for Mini Buggies. (American Sportworks, HammerHead, Carter, etc) |
 |
|
|
Thread Tools |
|
#1
09-14-2013, 04:25 AM
|
|||
|
|||
Replacement motor mount inserts for SunL GY6 150
I have been looking around for replacement motor mounts for the GY6 150engine. The right side insert is badly worn out, basically shot due to neglegence by the previous owner. I was going to rob 1 from an extra engine I have from a different project but I would rather install new ones if I could find them. Does anybody know if they are avaliable? I may just make my own out of automotive polyurethane style bushings or out of some teflon bulk stock that I've been hanging on to for a number of years now if all else fails. Also is there a prefab puller / press for removing them? I have started on a prototype of my own just in case for the mean time.
|
|
#2
09-14-2013, 06:47 AM
|
||||
|
||||
|
at one point, i was looking for the same item, along with swingarm bushings. I think metalstudman found a source for one of those items. you may want to check with BMI or buggy depot. I'd be careful with going with a stiffer material on the engine mounts--wouldn't want to crack the case.
|
|
#3
09-14-2013, 10:57 AM
|
|||
|
|||
|
x-bird, that's a good point about the case. I 'll check with the 2 sources you mentioned. Thanks for the help.
|
|
#4
09-14-2013, 11:17 AM
|
|||
|
|||
|
x-bird, I found the front motor mounts @ Buggy Parts NW. They are sold individualy. Thanks again for your help.
|
|
|
|
