|
|
|
|||||||
| 150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
|
Thread Tools |
|
#1
09-23-2015, 06:45 PM
|
||||
|
||||
Carbide 7150 Electrical Box
I'm putting the engine back in the carbide but i don't remember what went were
Can someone take a pic of theirs so i know were what goes? also i don't remember how the oil cooler hooked back in the engine a pic of that if possible. i got a big square plug and i don't know were that plugs into. i'll get a pic of it and post it. |
|
#2
09-24-2015, 12:10 AM
|
||||
|
||||
|
Here is a few pics i can't find were the one plugs go and there is a barrel connector with that i don't now were it goes. also do i have the oil cooler connected right? i didn't know if the right goes to the left and the left goes to the right or if the right goes to the right and the left hose goes to the left.
|
|
#3
02-29-2016, 09:46 PM
|
|||
|
|||
|
The big connector plugs into connector going to front of buggy and the blue bullet connector near back of buggy connects to nothing
|
|
#4
03-01-2016, 01:19 PM
|
||||
|
||||
|
As stated above the large connector should go to the main chassis harness. You should have 2 bullet connectors, a red/blk which is not used the one shown in your picture should go to the trigger on the stater.
|
|
|
