|
|
|
|||||||
| 150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
|
Thread Tools |
|
#1
08-05-2014, 06:08 PM
|
|||
|
|||
Carter Talon 150 getting oil on drive belt ??
Had to put new drive belt on and now after 10 minutes of riding it stopped pulling. Took cover plate off and oil is all over drive belt. I know its engine oil but how is getting on the drive belt ? Thanks for any help.
|
|
#2
08-05-2014, 07:02 PM
|
|||
|
|||
|
Transmission seal behind the clutch or engine seal behind the variator.
|
|
#4
08-05-2014, 09:57 PM
|
|||
|
|||
|
If you can run a small screw into the seal, you can pull it out pretty easy. The key is being careful not to damage the sealing surface of the shaft coming through the seal or the bearing behind the seal. Then install the seal, taking care not to damage the seal lips in the center. The seal should be installed flush with the surface. You need to try to press it in evenly.
|
|
|
