BuggyMasters.Com - An On Line Mini Buggy Forum and Go Kart Forum

Go Back   BuggyMasters.Com - An On Line Mini Buggy Forum and Go Kart Forum > Technical Discussions > Go Kart Engine and Torque Converter Tech

Go Kart Engine and Torque Converter Tech Forum for discussing go kart engines and torque converters (Briggs, Tecumseh, Suburu, Comet etc)

 
 
Thread Tools
  #1  
Old 04-16-2012, 11:07 PM
x45guy x45guy is offline
Lite Contributor
 

Join Date: Apr 2012
Posts: 67
Smile Torque converter driver ?

Anyone see a problem with running the end with the spring inboard?
I may have to get my driver to align with my driven.

I am putting an Ex 27 on a Murray Kilowatt.

Anyone have a good picture of the actual cart with the 6hp Tec and torque converter mounted up?

Got it with no motor or torque converter?

Thanks

Walt
  #2  
Old 04-17-2012, 01:16 AM
metalstudman1's Avatar
metalstudman1 metalstudman1 is offline
Super Moderator
 

Join Date: Aug 2009
Location: Belmont,NC (elevation 534')
Posts: 2,668
Default

Only pic of the rear I got before it was stolen. Buggymaster has a vid. with a walk-around in the review section.
Attached Images
File Type: jpg killowatt 4.jpg (98.6 KB, 16 views)
  #3  
Old 04-17-2012, 08:45 AM
x45guy x45guy is offline
Lite Contributor
 

Join Date: Apr 2012
Posts: 67
Default

Thanks for the picture. That sucks it got stolen. Do you think I can run the driven unit with the spring on the inside? . I may need to move motor over more to the right to line up with the driver.

I need to find a torque converter setup that will work with my 1 inch motor shaft and 3/4 inch jackshaft the kilowatt came with. Any suggestions?

Is there a good source for torque conv belts in different lengths?

Thanks
  #4  
Old 04-17-2012, 01:12 PM
metalstudman1's Avatar
metalstudman1 metalstudman1 is offline
Super Moderator
 

Join Date: Aug 2009
Location: Belmont,NC (elevation 534')
Posts: 2,668
Default

The set-up you'll need is the #40 or #44 series for your 1" shaft. With the belts that are available usually the driven is very close to the engine and turning the driven around doesn't allow for enough space for the helix (spring) side to be turned inward. The driven doesn't care which way it's turned!! I don't know any other source than searching the web for belts.
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:28 AM.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.