|
150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
Thread Tools |
#1
|
||||
|
||||
replacement motor for a kandi buggy
I was looking around good ole ebay and noticed complete new engines with carb etc run about 300 bucks is that the norm? also how do I know if min is a short or long version? I was hoping to find one modded from a vendor with a warentee but have not found anything thus far any suggestions. I don't have very deep pockets but would like to have the buggy reliable and fun for the family. right now it burns about as much oil as it does gas so the motor is pretty whooped. thank you for any help guys.
|
#2
|
|||
|
|||
You could do a topend kit for less than a hundred and go to a 58.5 and have a good running little buggy again as long as everything else is intact.
|
#3
|
|||
|
|||
I think the model of the engine is stamped on the block and might help you determine the kind that you have.
__________________
KD-150GKM-2 11g sliders, Iridium NGK, Orange coil, UNI oiled filter, smoother intake manifold, drilled muffler |
#4
|
|||
|
|||
You can buy modded gy6 engines. BD has a few. But. They are double than what you can buy stock. Can mod it yourself for half what they charging. But if you don't want to mess with doing it yourself. Then BD. Do have some options in what you might be looking for. They do honor their work.
|
#5
|
||||
|
||||
if you like you can give me a call, my shop rebuilds engines or i can get you a new one. or best of all i would be happy to help you make an educated decision to see what suits your budget and situation and options. you wouldnt even be obligated to spend a cent w/ me and advice is free. i'm in the shop usually after 3pm on weekdays and 9-5 on weekends (941) 286.6703 http://www.gotbuggy.com/
__________________
"LUCIFER" JOYNER JD400, CROSSHAMMER 250R, YERF GX150, CROSSFIRE MBX150, BMS 800V-TWIN '16 RZR 900s , '17 ACE 900XC, '99KX250, '94 KDX200, '18 SSR SR170TX |
#6
|
||||
|
||||
thanks will give you a shout jersey devil
|
|
|