![]() |
![]() |
|
150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
|
Thread Tools |
#1
|
|||
|
|||
![]() ![]() Last edited by xTylerx1324@aol.com; 09-25-2015 at 04:22 PM. Reason: bad url link |
#2
|
||||
|
||||
![]()
That spacer goes between the reverse box and the engine. It should fit into/around the edge of another spacer that has a step on it. The pair of them are right next to the gearbox itself and set the distance of the box from the engine so the sprockets line up.
|
#3
|
|||
|
|||
![]()
is there anywhere it could go because i dont have a reverse, or are you talking about the transmission box?
|
#4
|
||||
|
||||
![]()
Doh! moment there on my part; from it's condition, i'd feel pretty confident in say that it's not an internal part in the trans. too dirty on the outside of it. most likely fits on the shaft between the sprocket and engine side, again for helping set the sprocket alignment.
|
#5
|
|||
|
|||
![]()
Thank you! that's definitely where it went but my lack of oil seal was messing up my alignment on the final drive shaft
|
|
|