|
|
|
|||||||
| 150cc GY6 and Under Engine Tech GY6 and Smaller Technical Discussion Forum |
 |
|
|
Thread Tools |
|
#1
04-26-2013, 09:25 PM
|
|||
|
|||
Asw Quantom Carbide 150cc
How can i get more bottom end? With out doing any motor work it runs great so don't really want to mess with it. I seen where people change sprockets and gears but any suggestions? Where can you even buy parts other than the stock parts? Thanks in advance
|
|
#2
04-26-2013, 10:07 PM
|
||||
|
||||
|
Welcome to the forum Pat, glad to have you here! You can find lots of parts for these buggy's on line just by gooling your make and model, but for some real honest and professional help and advice you have to go to Tom @ sycpowersports, his header info is at the top of our forum page! I promise you will be satisfied with the result you get from this man, just ask anyone on this forum who has dealt with him!!!
|
|
#3
04-27-2013, 06:59 AM
|
||||
|
||||
|
Welcome Pat.
The guys took some time to help address these questions in this thread. Take a look. http://buggymasters.com/forum/showthread.php?t=4191
__________________
My Yerban assault vehicle: 2.2mm stroker crank, 62mm Nikasil cyl, Taida large vavle head, American made valve springs, ported intake manifold, TM 28mm carb, stock CDI, Bando coil, TK exhaust, stock CVT except for the 14g sliders, 13/40 internal gears, 16T drive, 31T axle sprocket, 22" rear tires, and ONE BIG POTATO CANNON mounted on top..........
|
|
|
|
