|
Mini Buggy General Discussion General Discussion forum for Mini Buggies. (American Sportworks, HammerHead, Carter, etc) |
|
Thread Tools |
#1
|
||||
|
||||
Need a little Yerf info ...
I was wondering if someone(s) could do me a favor and break out the measuring tape.
I need to know the dimensions of a 3203's front roll hoop, height from the top of the hoop down to the top of the cross bar it mounts to, and the width at the outside of the tubes at the top of the roll hoop. I don't need the bottom width. The other one I'm after is the installed width outside of driver to outside of passenger of the base and sides of a pair of the bucket seats in a spiderbox. Thanks ... |
#2
|
||||
|
||||
Got it covered.
|
#3
|
||||
|
||||
Post up the dims you got so everyone can have them. This way new people can use the search instead of starting a new thread.
__________________
If the only tool you have is a hammer, Then all your problems look like nails. |
#4
|
||||
|
||||
What i ended up with is purely my own creation. made a front hoop out of junk tube and tacked one of the old top bars to it to get the headroom and bar angles i wanted... definitely doesn't match anything yerf built ;~) Tubing is being bent for me as we speak ... (my buddy at anvilcraft pulled a guy off the Statue of Lib job for my yerf )))
I do know just from looking at the pics of spiderbox works-in-progress how they put in the extra width for the bucket seats. I was considering a pair of the $29 Jegs buckets, but at 21-wide each, I'd have to widen the back frame of mine 5-6 inches each side. Too much involved to do it easily so it will become a single seater. |
|
|