|
|
|
#1
04-25-2013, 07:30 PM
|
|||
|
|||
Carbide 150
I believe my carbide is running lean, under acceleration it will back fire and run very rough and stall.
|
|
#2
04-25-2013, 07:58 PM
|
|||
|
|||
|
Did it happen all of a sudden or has it been that way for a while?
|
|
#3
04-26-2013, 03:18 AM
|
||||
|
||||
|
Check for air leaks around carb area. While motors running spray around carb to se if idle changes. Donot spray inside filter intake just around the carb if idle changes you have a leak.
__________________
2. 150cc carters. 1. Baja reaction 150cc dr2 variators Jerseydevil hp. Pipes unifilters gates belts. Yellow main springs hd. Orange coils. |
|
#4
04-26-2013, 06:32 AM
|
|||
|
|||
|
This has been an on going issue.
|
|
#5
04-26-2013, 06:33 AM
|
|||
|
|||
|
Ok, thanks.
|
|
#6
04-26-2013, 12:41 PM
|
|||
|
|||
|
Def sounds like a lean running issue. Maybe another easy way to tell is to back out the A/F screw 2 turns and see if the problems clear up a bit. Could be a timing issue. My old talon did that and it was the crank sensor single wire grounded out on flywheel from rub through.
|
|
|
